Polaris PVCR 3200 IQ Home Aqua Black, Руководство по эксплуатации, Страница: 85 / 175

85
5.
To switch off the vacuum cleaner, push and hold down the button, then set the power switch to
"O" position.
CLEANUP PROGRAMS.
To improve the cleanup quality, the vacuum cleaner has got different programs which can be launched on
the control panel, or the control unit.
At switching over from the basic program to another mode with subsequent relaunch the basic program,
then the vacuum cleaner reschedule the cleanup path and can vacuum an area having been already cleaned.
Prior to run a cleanup program, make sure to energize the vacuum cleaner.
1.
Classic or basic cleanup program.
To run it, push the button on the vacuum cleaner or on the control unit. (Fig. 9)
2.
Spiral motion (Local cleanup).
Spiral motion mode ("Local cleanup") is intended fro cleaning intensively contaminated areas. To start
cleaning, you should push the
button on the control unit (Fig. 11)
3.
Suction power increase mode "Maximum".
The "Maximum" cleanup mode enables the vacuum cleaner to operate with an increased suction power. To
activate the mode, push the button on the control unit . (Fig. 12)
4.
Cleanup along walls.
To start cleaning along walls, push the respective button on the control unit (Fig. 13)
5.
Random cleaning.
To start the cleanup program, push the respective button on the control unit. (Fig. 14)
SETTING THE CURRENT TIME AND THE CLEANUP START TIME.
By using buttons on the control unit you can set a desirable time of starting the cleanup. At that, the current time
shall also be set.
Having the timer pre-adjusted, the vacuum cleaner automatically turns on and starts cleaning daily at preset time.
I/O switch on the device body shall be in ON position, the accumulator shall be charged and connected.
Setting the current time.
Push the button on the control unit, this causes timer illumination on the display. "Hour" indicator light is
flashing on the display. Use or buttons to set a desirable time, and
or buttons to switch over from hours to minutes and vice versa. To save the adjustments, push the button
on the control panel. This causes uttering a beep meaning that the adjustments have been saved. (Fig. 15)
Setting the cleanup start time.
Push the button on the control unit, this causes timer illumination on the display. "Hour" indicator light is
flashing on the display. Use or buttons to set a desirable time, and or buttons to switch over from
hours to minutes and vice versa. To save the adjustments, push the button on the control panel. This causes
uttering a beep meaning that the adjustments have been saved.
To reset parameters, push and hold down the
button for 4 seconds. Once the adjustments are saved, the device
utters a transient beep.
Replacement of power supply elements causes resetting of parameters. Therefore, remember to re-adjust the
time after electric battery replacement.
ACCUMULATOR CHARGING
1.
CHARGING BASE USAGE
During use of the charging base, the necessity of charging the accumulator and the charging base location
is automatically determined by the device. The I/O switch on the device body shall be in the "I" position.
Place the charging base right against the wall beside a power outlet in a room to be cleaned, insert the adapter plug
into the outlet. This causes illumination of the signal indicator on the base.