Polaris PVCR 0833 WI-FI IQ HOME, Руководство по эксплуатации, Страница: 29 / 140

29
Device status Indicator color
Charging/Low Battery Flickering orange
Charged/In cleaning mode Green, constantly lit
Gives an error message Flickering red
BATTERY CHARGING
1.
USING THE CHARGING BASE
When using the charging base the need to charge the battery is determined automatically by the device.
The I/O switch on the vacuum cleaner housing must be in the I position.
Place the charging base against the wall of the room to be cleaned next to the outlet, and then insert the
adapter plug into the outlet. The base signal indicator will light up.
Remove the obstacles 1 meter from both sides and 2 meters from the front of the charging base. (Fig. 5)
Aways use the battery base under normal operating conditions.
Do not leave the adapter plugged in after the battery is charged completely.
Do not leave the charging base on the floor when not in use.
Attention! It is strictly forbidden to short-circuit the contacts of the charging base with metal objects!
Fully charge the battery before long-term storage.
2. CHARGING THE BATTERY WITHOUT USING A CHARGING BASE
1. Before charging the battery, the vacuum cleaner must be turned off. Disconnect the device with the I/O
switch on the device housing moving it to the O position.
2.
Insert the adapter plug into the charging socket on the vacuum cleaner housing.
3. Plug in the adapter. The indicator of the Auto button will flash orange.
4. Charging is complete when the Auto button indicator turns green. Unplug the adapter from the grid and
from the vacuum cleaner. Do not disconnect the charger until the battery is fully charged.
Note:

If the device is not used for a long time, it is recommended to charge the battery every 3 months, having
previously completely discharged it for which it is necessary to start the device in operation for the maximum
possible time.

It is recommended to charge the battery only when the device indicates that it will be discharged soon,
or when it is already completely discharged. It is better to turn on the device when the battery is fully charged.
The total battery life of the device with a new battery can be up to 200 minutes. Over time, this value may
decrease.

A damaged battery must be disconnected and disposed of.
BATTERY EXCHANGE
1. Turn off the device.
2.
Place it with the bottom panel up.
3. Using a Phillips-head screwdriver (not included), unscrew the screws of the battery cover and remove the
cover by hooking it from the side of the screws.
4.
Remove the old battery from the compartment and disconnect its connector for which click on the latch
of power socket of the vacuum cleaner and pull the battery connector out of it. To connect a new battery,
insert the battery connector into the power connector of the vacuum cleaner until it clicks. Carefully place
the battery in the compartment without pinching the connecting wires.
5. Replace the battery cover by inserting the plastic tabs into the holes. Tighten the screws.
DUST COLLECTOR CLEANING
- Press the button on the dust collector (Fig. 6)
- Remove the container by pulling the handle at the bottom