Instr 9927916
Rev 02 2018-07
Page 7 of 11
ii. Remove five push pin rivets
E
from LH side
of dash: two at center cupholder, two at
instrument cluster, and one on underside of
dash above cupholder.
iii. Remove three push pin rivets
F
from RH
side of dash: two inside upper storage area
and one on underside of dash above
cupholder.
iv. Remove upper dash from vehicle and set
aside.
NOTE
HVAC vehicles: Either cut cable ties securing ducts
to vents, or leave cable ties intact and partially lift
upper dash to gain access for audio installation.
4. Install speakers and speaker harnesses.
a. Using 1/8 inch (3 mm) drill bit, drill out four
fastener dimples
G
. Only drill deep enough to
penetrate panel surface and enter pre-drilled
bosses on opposite side of panel.
NOTE
All holes drilled from rear (passenger) side of panel.
Forward side shown below for reference only.
