Instr 9927916
Rev 02 2018-07
Page 11 of 11
b. Using 1 inch diameter hole saw, drill through
lower center cavity for installation of auxiliary
input
u
.
Remove nut and rubber gasket from auxiliary
input
u
, route wires rearward through opening,
then reinstall gasket and nut.
c. Reconnect electrical harnesses disconnected
in Step a. above, then reinstall control panel
using two retained rivets
N
.
NOTE
Auxiliary input will be connected to head unit in Step
9.
8. Reinstall all access EXCEPT upper dash
cupholder. See Step 3.
9. Hold head unit
q
near upper dash cutout and
make the following connections:
a. Join connector 5A on harness
t
to head unit
connector 1A.
b. Join connector 11A on antenna harness
s
to
head unit connector 1D.
c. Join connector 7A on auxiliary input
u
to head
unit connector 1B.
d. Join connector 7B on auxiliary input
u
to head
unit connector 1G.
e. OPTIONAL: Join dash amp AUDIO SOURCE
(signal) connector to head unit FRONT OUT
connector 1E.
f.
OPTIONAL: Join subwoofer AUDIO SOURCE
connector to head unit REAR OUT connector
1F.
g. OPTIONAL: Join subwoofer AMP ON
connector
OR
dash amp AUDIO SOURCE
(remote) connector to head unit REMOTE ON
connector 1C.
NOTE
Joining
BOTH
subwoofer AND dash amp to head
unit requires remote splitter harness (included with
Dash Amp Kit; see Dash Amp Kit instructions for
detail).
10. Install head unit (with bezel) into upper dash
cutout using two retained push pin rivets
A
.
11. Reconnect black negative (-) cable to battery, then
reinstall under-seat storage compartment and
driver’s seat.
FEEDBACK FORM
A feedback form has been created for the installer to provide any comments, questions
or concerns about the installation instructions. The form is viewable on mobile devices
by scanning the QR code or by clicking
if viewing on a PC.
FEEDBACK FORM
