Instr 9927916
Rev 02 2018-07
Page 6 of 11
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn
ignition switch to “OFF” position and remove key.
WARNING
Ensure red positive (+) battery terminal is
COMPLETELY COVERED by protective boot.
Accidental tool contact across both battery terminals
will result in high current electrical arc, and may
result in battery explosion. Death or serious personal
injury may occur.
2. Flip up passenger seat bottom (CREW: right rear
passenger seat bottom) and remove underseat
storage compartment. Disconnect black negative
(-) cable from battery.
3. Gain access.
a. Remove hood.
b. If windshield is installed, then open it or remove
it as required to gain access to upper dash.
c. Remove upper dash cupholder by removing
two push pin rivets
A
, then sliding cupholder
rearward. Retain rivets. Cupholder will not be
reused.
d. Tilt steering wheel to full down position. Detach
instrument cluster hood by removing two push
pin rivets
B
, then slide hood (with instrument
cluster) rearward. Disconnect instrument
cluster wiring harness. Retain rivets.
e. Open door to upper storage compartment.
Remove four screws
C
from forward wall of
compartment, then remove compartment/door
assembly from dash. Retain screws.
f.
Remove upper dash.
i.
Remove six push pin rivets
D
along
forward edge of dash.
