Instr 9927476
Rev 01 2016-11
Page 4 of 12
5. Remove the front storage bin and cover
D
by
removing two screws
F
and six push pin rivets
E
.
NOTE
Your vehicle’s factory tool kit contains a pliers
specifically designed for the removal of push pin
rivets. See photo below.
6. Remove winch cover
G
from the vehicle by
removing four screws
H
. Retain screws for
installing new winch cover supplied in the kit.
NOTE
ACE 570 shown, ACE 900 XC is slightly different.
7. On ACE 900 XC models, remove four screws
1(
,
holding the empty winch bracket
q
, as seen in the
figure below, from the vehicle and remove winch
bracket for use in the next step.
WINCH ASSEMBLY
1. Place fairlead mounting carriage bolts
l
into
winch bracket as shown. Assemble winch
w
into
mounting bracket
q
as shown below using the
supplied screws
k
and torques to specification.
TORQUE
20 ft. lbs (27.1 Nm)
2. Install the Fairlead
d
your kit came with(Autostop
Fairlead shown) onto the winch bracket
q
using
supplied locking nuts
2)
and torques to
specification.
TORQUE
20 ft. lbs (27.1 Nm)