Instr 9927476
Rev 01 2016-11
Page 8 of 12
• See the illustration below for proper wireless remote
operation.
AUTOSTOP OPERATION
The Autostop system is meant to help prevent
damage to the winch system from over-tightening of
the rope, but is not meant to prevent all foreseeable
winch damage. The winch system is very powerful
and care should be exercised whenever it is in
operation. The winch operator is always responsible
for using the winch properly and the Autostop system
should only be used as a secondary preventive
measure to help prevent damage to the winch from
over-tightening the rope.
The Autostop system works when the black rubber
puck nears the aluminum fairlead
h
. Stop magnets
j
in the puck trigger sensors in the fairlead, which
prevent the winch from pulling in the rope any further.
During final inspection, confirm that the Autostop is
functioning properly. Troubleshooting steps are given
in that section to help diagnose and correct any
problems.
GEAR SELECTION
WARNING
Attempting to shift the winch while the rope is under
tension is dangerous and can result in injuries or
death. Make sure the winch rope is not in tension
before shifting the winch between gears.
Your winch is equipped with three different gear
settings. High, Neutral and Low. When in neutral the
“N” marking will show thru the cutout window on the
shift knob. See photo below.
