Polaris 2882238, Руководство пользователя, Страница: 6 / 13

Instr 9927471 Rev 01 2016-11 Page 6 of 13
4. Install winch
q
onto the winch mounting bracket
using four screws
j
, split washers
2$
, and flat
washers
2%
as shown and torque to specification.
TORQUE
20ft. lbs. (27.1 Nm)
5. Insert winch rope
r
through autostop fairlead
s
and rubber stopper
g
as shown. Install hook
w
onto the rope using clevis and cotter pins. HINT:
Attach a plastic cable tie to the end of the rope and
feed the cable tie through the rubber stop. Use a
little wax or other mild lubricant on the rubber stop
and pull the rope through the rubber stop using the
plastic cable tie.
6. Reinstall bumper assembly
A
onto the vehicle
using seven retained screws
B
.
7. Connect yellow
y
and blue
u
cables to the
corresponding posts on winch assembly. Route
cables from winch assembly to the contactor posts
as shown and torque nuts to specification.
TORQUE
4ft. lbs. (5.4 Nm)
8. Connect blue
u
and yellow
y
cables to contactor
posts as shown and torque to specification.