Instr 9927471
Rev 01 2016-11
Page 5 of 13
CONTACTOR INSTALLATION
1. Install contactor
a
to center frame member under
hood using two screws
1(
as shown. Tighten just
until snug. Do not overtighten.
2. Connect short (250mm) red
i
and black
o
cables
to the vehicle bus bar as shown. Connect the other
ends of cables to their respective colored posts on
contactor and torque to specification. Slide the
cable covers on as shown.
TORQUE
4ft. lbs. (5.4 Nm)
WINCH INSTALLATION
1. Install winch mounting bracket
f
onto the front
bumper
A
using four screws
k
, nuts
2@
, and
washers
2^
on lower side and two self-tapping
screws
2&
at the top as shown. Tighten bolts and
nuts to specification, but tighten self-tapping
screws just until snug.
TORQUE
20ft. lbs. (27.1 Nm)
2. Install new grill screen
d
on front bumper
A
using
retained two screws
D
.
3. Install auto stop fairlead
s
to winch mounting
bracket
f
using two screws
2!
and nuts
2@
and
torque to specification.
TORQUE
16ft. lbs. (21.7 Nm)