Instr 9927471
Rev 01 2016-11
Page 4 of 13
INSTALLATION INSTRUCTIONS
PREPARATION
1. Shift vehicle transmission into “PARK”. Turn key to
“OFF” position and remove from vehicle.
2. Remove the driver seat and disconnect black
negative cable first and then red positive cable
from the battery.
3. Remove the front bumper
A
by removing seven
bolts
B
.
4. Remove grill screen
C
from bumper by removing
two screws
D
. Retain screws for reuse.
5. Detach rubber latch
F
on both sides of vehicle
and open the hood
E
.
6. Remove seven screws
G
securing drive shaft
cover
H
to the floor. Save fasteners for use during
reinstallation. Remove drive shaft cover
H
from
vehicle.
POWER CABLE KIT (PN 2881684)
INSTALLATION
1. Route power kit cables (red and black)
2*
from
battery to bus bar terminals following the vehicle
main wire harness as shown. Do not connect
cables to battery and bus bar terminals at this
time.
2. Install red and black power cables kit
2*
to vehicle
bus bar as shown.