If you do not program Timer 1, you will not be
able to program Timer 2 either.
2. At any point, you can
press
SET/START/
STOP
button
and the word
TIME 1
will lock on
display.
3. The tens of the minutes will now be flashing.
As in the
TIME
selection, use
the
SELECT
button to move up
, or
the
SIGNAL/LIGHT
button to move down
.
4. When the number you want is displayed,
press the
STORE/LAP
button
to lock in
your selection.
5. The single minute’s digit flashes now. Again,
use
the
SELECT
button to move up
, or
t h e
S I G N A L / L I G H T
b u t t o n t o m o v e
down
.
6. When the correct digit is displayed,
press
STORE/LAP
button
to lock in your selection.
7. The first digit representing tens of seconds
flashes now. Again, use
the
SELECT
button
to move up
, or
the
SIGNAL/LIGHT
button
to move down
.
8. When the correct digit is displayed,
press
the
STORE/LAP
button
to lock in your se-
lection.
S T E P - B Y - S T E P I N S T R U C T I O N S
F O R S E T T I N G T H E T I M E R S
1. In the time mode
press the
SELECT
b u t t o n
three times.
SET
appears on the
program status line (bottom of the display), and
the display cycles through
TIME 1
,
LIM
, Re-
covery and
SPLI
or
TIME.
Note: In case you do not wish to program the
Timers at all and wish to proceed directly to
programming your personal target heart rate
zone, please,
press SET/START/STOP
button
twice.
Note: Timer 2 may also be displayed at this
point, if Timer 1 has already been set. However,
20
21
STORE/LAP
PROTRAINER NV
RECOVERY
RECOVERY
STORE/LAP
PROTRAINER NV
STORE/LAP
PROTRAINER NV
STORE/LAP
PROTRAINER NV
PROTRAINER NV
STORE/LAP
PM
PM
OR
