Polar Electro Cardio GX, Руководство пользователя, Страница: 37 / 59

37
1. Open the reception tool. Go to System Settings .
2. Click the arrow in the main base station's information box.
3. Click Remove . All base stations are removed from the system.
4. Reset the old base stations in the system. See more details in Resetting base station .
5. Set up the base stations normally. See more details in Setting up base stations .
6. After setting up the base stations, synchronize the connectors with the new base station com-
bination. See more details in
Synchronizing connectors with new base stations .
If the the main base station is replaced in the Cardio GX system, all the base stations in the system must
be set up again.
TEACHING CONNECTORS
Before you can use transmitters for online monitoring, the connectors must be introduced to the system. It
takes only a few minutes, and it has to be done only once for every connector. You can teach up to 80 con-
nectors to the system.
1. Open the reception tool. Go to System Settings .
2. Make sure the base stations are set up. The base stations should be available in System Settings .
3. Connect the main base station to the PC or to the router with a network cable provided in the set.
4. Switch on the main base station. Wait until and are lit on the main base station. It takes
approximately 1 minute.
5. Plug the power cable into the charger and insert the (new) connectors into the charger.
6. Wait until
is lit on the main base station. New connectors appear into the New box.
7. Select a connector under New . Wait until the software assigns a number for the connector. It may take
up to 15 seconds.
8. Pick up corresponding number sticker and remove the connector with a continuously lit green light from
the charger.
9. Click OK and attach the sticker onto the connector. The connector moves into the connectors box.
10. Repeat steps 5/7 to 9 until you have taught all the connectors to the system.
If you re-insert the taught connectors into the charger, their battery status is shown in the connectors box.
See also Removing connectors from the system .
REMOVING CONNECTORS FROM THE SYSTEM
After removing a connector from the system, you can re-teach the connector at any time.