EN
4
Press
key for emergency alarm. This is used only in case of a real emergency in order to alert people
around, and configured phone numbers.
2.3. Display screen
The screen shows:
“
SF
” when system is armed
“BF
” when system is stay armed
“
CF
” when system is disarmed
”
99
” when system is in alarm mode
“
F1
” if phone line is disconected
“F2
” if interference alarm is triggered
3. SYSTEM CONFIGURATION
3.1. Connecting system
Connect the alarm system to the telephone line (if available), plug AC power adapter and activate the
battery by On / Off switch. Connect the siren. The system will give a short beep and a voice message, when
initialization is succeeded.
All settings must be done in “Disarm” state.
All configuration operations that will be
correctly executed
will receive a
long confirmation sound
, and
wrong or unsuccessful operations
will receive
two short beeps
.
Note:
The system comes with included accessories paired from factory: motion sensor, magnetic contact
and remote controls. Check functionality of sensors, and if their trigger is displayed with a zone number on
the screen. Adding accessories is only recommended for additional sensors or in case of malfunction.
3.2. Add/Remove remote control
Add:
*0*
Enter * 0 * command from system keyboard, system enters remote control learning mode and
a 10-second countdown starts. Trigger / Press a key on the remote control to register with system. If
successfull, system confirms operation with a long sound.
Delete:
*02*
This operation will delete all remote controls registerd in the host.
3.3. Add/Delete detector
Add:
*01*
Enter *01* command, system enters detector pairing mode and starts a 10 seconds countdown when
you have to trigger detector , in order to be registerd. If successfull, system confirms operation with a long
sound.
Delete:
#8996#
This operation will delete all detectors registerd in the system.
3.4. Add/Delete phone number
Add:
# + [1~6] + [Phone No.] + #
Example: To set phone number 0700123456 to position 1, type command:
# 10700123456 #. The system will confirm by repeating phone number on position 1 with voice message.
[1 ~ 6] represents the 6 positions where phone numbers can be stored.
If you want to replace a phone number, enter the command for desired position with desired phone number.
Delete:
# + [1~6] + #
Entering this command from keyboard will delete the phone number from selected position.
Ex: Command # 1 # will delete the phone number on position 1.
3.5. Alarm delay
# + [7] + [0~99] + #
When alarm is triggered, the system should respond immediately and siren sound. Alarm delay can set the