5mm
5mm
Component assembly
1A -
Assemble together the extrusion support brace with two open ‘sliders’ using
x4 (A) M8 washers
and
x4 (B) M8x12mm button head bolts
-
Fig 1A
1B -
Assemble together the x2 extrusion top supports with x2 open ‘sliders’ each using
x2 (A) M8 washers
and
x2 (B) M8x12mm button head bolts
-
Fig 1B
1C -
Ensure there is a 5mm gap between the brace / support bracket and the sliders to allow easy fitment to the trolley or stand -
Fig 1C
1
1A
1B
1C
Not to
scale
1C
1A
2A
2C
2B
2D
2D
Assembly on to trolley / stands.
2A -
Take the assembled support brace and sliders and position them above your trolley / stand facing forwards. -
Fig 2A
2B -
The sliders on both ends of the support brace need to be inserted in to the slider gully -
Fig 2B
The support brace needs to be level at all times.
2C -
Position the support brace at the desired height and tighten bolts in a diagonal pattern whilst the brace is level to fix its height. -
Fig 2C.
Tighten appropriately.
2D -
There are matching cut-outs on each side of the support brace, these denote the centre point of the height of the fixing patterns. Although this may not be the centre
of the screen itself it will allow you to work out the desired height of the screens if you do want them to be at a very specific height -
Fig 2D
2
Centre point of
mounting bracket
(height)
Centre point of support
brace, align joining plates
with this point to centralise
horizontal extrusions.
Bx4
Bx4
Ax4
Ax4
