Assemble screen mounts with sliders
6A -
Assemble
x2
‘TV mounting plate sliders’ on the inside of a TV mounting plate using
x4 M8 x 12mm button head bolts
-
Fig 6A
6B -
Leave a 5mm gap between the slider and the mounting plate -
Fig 6b
6C -
Repeat above steps so you have two matching assembled mounting plates ready to install.
Fit and secure TV mounting plates to horizontal extrusion
7A -
Slide each mounting plate on to the horizontal extrusion guiding the upper and lower sliders in to the corresponding slider gullies -
Fig 7A
7B -
After each TV mounting plate is fully installed on the horizontal extrusion fit both extrusion trim pieces -
Fig 7b
7C -
Repeat above steps so you have both mounting plates installed on the horizontal extrusion, one on each end and secured with the end trim.
7D -
Lightly tighten upper and lower fixings on both sliding mounts to prevent their movement whilst mounting the screens. -
Fig 7D
6
7
5mm
5mm
Bx4
Ax4
6A
6C
x2
x2
6B
6B
Not to
scale
7A
7A
7B
1
1
2
2
7D
Tighten
Tighten
Tighten
Tighten
