Assemble extrusions together
Note -
Lay extrusions on a soft surface so as not to mark the paint finish,
with assistance you can assemble the extrusions whilst they’re upright.
3A -
Assemble together the two extrusions via the black joining plates
using
x3 (D) M8x12mm
cap head bolts -
Fig 2A
Secure horizontal extrusion in place.
5A
- One end at a time, insert a studded slider in to the upper and lower slider gullies.
5B
- Move sliders along the gully until you reach the brace, lift one end of the extrusion slightly and direct the slider’s stud in to the corresponding hole in the brace.
- Fig 5B
5C -
Repeat
step 5B
for the opposing end of the horizontal extrusion, also align the upper studded sliders with the lower
studded sliders.
- Fig 5C
5D -
Insert the
x2
‘Top support braces’ into the slider gully and position the corresponding hole over the studs on the upper two sliders -
Fig 5D
5E -
Centre the extrusion by gently moving it left or right until the meeting point of the two joining plates aligns with the cut-out centre point of the support brace. -
Fig 5E
5F -
Secure the horizontal extrusion once centred by adding fixings to both ‘top support braces’
x4 (A) M8 washers
and
x4 (E) M8 nuts
-
Fig 5F
5G -
Tighten the
x4 M8 x 12mm button head bolts
(from
Step
1B
) and secure the
x2
‘Top support braces’ in place -
Fig 5G.
Tighten appropriately.
5H -
Ensure the horizontal extrusion is still level before proceeding.
Position horizontal extrusion on to trolley / stand.
4A -
Two persons should lift the horizontal extrusion up and over
the support brace installed at
Step 2
.
4B
- Bring the extrusion to rest lining up the centre of the joining
plates with the centre point of the support brace.
3
5
4
Dx3
900mm / 600mm extrusion
900mm / 600mm extrusion
Black joining plates
Centre point
5A
Tighten
Tighten
5B
Centre point
Align with
centre point
5D
5B
5C
5E
5F
5G
Rear view
Front view
Ax4
Ex4
