0000110982/231018/A SER
EN - 8
Fig. 4.3.1a Inserting the DMF bracket into the hose reel
Fig. 4.3.1b Inserting the DMF bracket into the hose reel
Fig. 4.3.1c Tightening the bolts on the DMF bracket
Fig. 4.3.1d Mounting the operating springs on the hose reel drum
4.3
Mounting options
4.3.1 Direct mount fan
The SER includes ceiling or wall mounting attachment foot. All
SER versions except for 1050-200 can be connected to a
central exhaust system or fitted with a fan.
First, mount the fan with the reel upside down on the floor and
then mount the complete reel to its intended position, as
shown in
fig. 4.3.1a
through
fig. 4.3.1d
.
•
With hose reel securely installed in position or placed on a
level working surface, insert the DMF Bracket with the bolts
and hand tighten the nuts into position (A).
•
Place rubber collar on the inlet spigot of fan (B).
•
Align fan bolt holes with the holes in the fan bracket. Insert
bolts and tighten slightly. Slide the bracket up and down
parallel to the A-frame center to align with the hose reel
outlet. Tighten bolts to ensure the unit is properly secured
(C).
•
Unfold the rubber collar over the reel’s spigot (For North
America customers, a synthetic rubber-coated sleeve is
applied with two hose clamps) (D).
Note: Direct mount fans are PV Model FUA-1800, 2100 or
2700. Refer to FUA fan product data sheet for additional
data.
4.3.2 Micro Switch MSR-24/2
To insert the micro switch, follow these steps, as shown in
fig.
4.3.2
.
•
Insert the circuit-breaker’s feeler (A) into the hole (B).
•
Secure circuit-breaker using enclosed screws (C).
•
Check that the circuit-breaker can move freely in both
directions.
•
Pull out the hose and obtain 4 notches on one of the lock
segments.
•
Mount the operating springs (D) on the drum by loosening
two of the screws (E) that hold the drum.
•
Refasten screws.
•
For electrical installation, refer to the electrical connection
schematic in the manual for the specific controller that is
being used in the installation.
Fig. 4.3.2 Inserting the micro switch
