9
Floor Level Installation for Suspended Floors
Installation –
Suspended Floor
When the adhesive has set, remove any excess
mix and masking tape then make connection
between the shower tray and waste pipe. The
shower tray and all connections
MUST
now be
checked for water tightness, flow and adequate
drainage over the entire area.
DO NOT PROCEED IF NOT SATISFIED.
After all checks and adjustments, tile and then
seal along the tiling line with silicone sealant.
If fitting a shower enclosure refer to the
manufacturers installation instructions.
Place the shower tray
A
onto the wet adhesive
ensuring that it is fully supported by the mix.
Check the level of the top rims only as the
shower tray has a built in fall for adequate
drainage.
Note! Ensure tray is fully stuck down –
weight down if necessary to ensure level and
that good contact is made with the adhesive.
Use installation compound adhesive or a suitable
contact adhesive to cover the full area under
the shower tray. Apply or trowel to a thickness
suitable to allow full adhesive support of the
shower tray.
Note! Always follow the instructions supplied
with the adhesive.
7
8
5
6
Installation –
Suspended Floor
Silicone
