9
When the adhesive has set, remove any excess
mix and masking tape then make connection
between the shower tray and waste pipe. The
shower tray and all connections
MUST
now be
checked for water tightness, flow and adequate
drainage over the entire area.
DO NOT PROCEED IF NOT SATISFIED.
After all checks and adjustments, tile and then
seal along the tiling line with silicone sealant.
If fitting a shower enclosure refer to the
manufacturers installation instructions.
Before fitting, apply copious amounts of silicone
to the edges of the shower tray
A
against all wall
contact points.
This is especially important on any edges of
the tray that have been cut or trimmed.
Place the shower tray
A
onto the wet adhesive
ensuring that it is fully supported by the mix.
Check the level of the top rims only as the
shower tray has a built in fall for adequate
drainage.
Note! Ensure tray is fully stuck down –
weight down if necessary to ensure level and
that good contact is made with the adhesive.
Fit the waste unit to the shower tray following the
instructions supplied with the unit and protect
exposed threads with masking tape. Before
proceeding dry fit all items in-situ to ensure
compatibility and then screw the plywood level
into position.
Note! It is normal for the tray to appear
elastic when undertaking a test dry fitting.
Use installation compound adhesive or a suitable
contact adhesive to cover the full area under
the shower tray. Apply or trowel to a thickness
suitable to allow full adhesive support of the
shower tray.
Note! Always follow the instructions supplied
with the adhesive.
7
8
5
6
Installation –
Suspended Floor
Silicone
