13
7.5.
Replacing Lifting Tape (AR-200)
Replace the Lifting Tape in case of any kind of wear.
1.
Remove the Ceiling Hoist from the rail and place it where you can
safely carry out repairs.
2.
Remove both covers (
chapter 7.1
).
3.
Place the plug of the Hand Controls in the Ceiling Hoist.
4.
Remove Battery 1 (
chapter 7.2
) but keep the wiring connected.
5.
Fully unwind the Lifting Tape using the Hand Control. Keep manual
tension on the Lifting Tape. The bolt which attaches the Lifting
Tape (step 6) is located behind Battery 1. Turn the Spool
until the head of the bolt with the ‘BOLT STRAP’ label is
visible through the ‘BOLT STRAP’ hole.
6.
Turn off the Ceiling Hoist. You can do this by using the
Emergency stop.
7.
Disconnect the wiring from Battery 1.
8.
Remove the screw (
Hex 4
).
9.
Pull the Lifting Tape from the Ceiling Hoist.
10.
Remove the Central Suspension Point of the old
Lifting Tape.
11.
Push the new Lifting Tape through the opening
and guide it to the roll axle through the Battery
space as shown in
Figure 8
(red line).
12.
Push the loop through the bolt recess and apply
Loctite 243
(
Figure 7
) on the top thread of the
bolt, push it through the loop and tighten it.
13.
Replace the Central Suspension Point on the
Lifting Tape as shown in Figure 14 with
Loctite
243
.
14.
Replace the Battery and connect it (
chapter 7.2
).
15.
Check the operation by winding and unwinding the Lifting Tape.
16.
Test the new Lifting Tape with a load.
17.
If working properly; Place the covers (
chapter 7.1
).
Note!
Use the same bolt for the Lifting Tape because it is an
extra strong bolt (12.9), special for that function. Place the old
Central Suspension Point on the
new Lifting Tape. Use
Loctite
243
to fix the bolt in place in the
Central Suspension Point.
Inspection:
Ensure that the
Lifting Tape moves along 2 roles
and over the axle of the Strap
Tension Switch. The Ceiling Hoist
will not lift if the Lifting Tape
does not move along the Strap
Tension Switch.
Figure 7, bolt mount Lifting Tape
Figure 8, Lifting Tape guide
Loctite 243
Figure 9, example side Lifting Tape
Figure 10, Assemble of CSP and Lifting Tape Block
Loctite 243