Plextor PX-800A, Инструкция по установке и эксплуатации

Страница: 41 / 94

Section 2. Installing the PX-800A Internal ATAPI Drive
PX-800A Installation and Users Manual
33
Using Sound Boards and Audio Cables
Whichever category your sound board falls into, you will find that the
best source of information about installing the sound board in your
computer is the board's manual. Once you have successfully installed
the sound board in your computer, you can continue below for a
description of the different cable connections that need to be made.
If you need audio cables, you will have to purchase them. Refer to the
table below. A list of several vendors who offer audio cables is available
on Plextor’s web site.
Audio Connection Cable
Required
How to Connect It
MPC audio source MPC-
compliant
audio cable Connect to MPC audio
source, and to analog audio
output connector at the rear
of the Plextor drive.
Sound Blaster or
compatible sound
board Sound
Blaster-
compatible
analog audio
cable Connect to Sound Blaster-
compatible audio board and
to analog audio output
connector at the rear of the
Plextor drive.
Digital audio output Cable that’s
compatible
with SPDIF
or Digital-In. Connect to SPDIF or Digital-
In connector on sound board
(if sound board supports
digital audio) and to digital
audio output connector at the
rear of the Plextor drive.
Where to Go From Here
This completes the installation procedure. Go to “Section 3. Using Your
PX-800A” on page 35 to see how to use your PX-800A drive.