Plextor PX-800A, Инструкция по установке и эксплуатации

Страница: 29 / 94

Section 2. Installing the PX-800A Internal ATAPI Drive
PX-800A Installation and Users Manual
21
Select an IDE Configuration
Set the PX-800A’s jumper and cable it according to the desired
configuration. Keep these rules in mind:
•
For best DVD±RW and CD-RW performance, try to connect the
PX-800A to the IDE port that is not connected to the hard disk drive
or to a DVD or CD-ROM drive. In most cases, this will be the
secondary IDE port.
•
For best results, set the PX-800A to be the Master, if possible.
•
If you have only one device on a cable, always set its jumper as the
Master, never as the Slave.
Before PX-800A
Installation
How to Install the
PX-800A
A Hard disks connected as
Master and Slave devices on
primary IDE port; DVD-ROM or
CD-ROM drive connected as
Master device on secondary
IDE port. Remove the DVD-ROM or
CD-ROM drive, change it to
Slave, and re-connect it to the
secondary IDE port.
Set the mode jumper to Master,
and connect the PX-800A as
Master device to the secondary
IDE port.
Figure 8. How to install the PX-800A if your computer is originally
set up in configuration A