Plextor PlexWriter 8/2/20, Руководство по эксплуатации

Страница: 65 / 76

Appendix B: Installing in Windows
PlexWriter 8/2/20 Operation Manual
61
4. In the new window of devices, double-click on SCSI Controllers. This displays
all the SCSI interface boards currently installed in your system.
5. Double-click on the SCSI controller for the PlexWriter.
6. Go to the Driver tab.
7. Click on Update Driver.
8. Click on Next.
9. Click on Other Locations.
10. Use the Browse button and go to the \ADAPTEC\SCSIDRVR\ folder of the
PlexWriter CD.
11. Highlight the driver listed.
12. Click on OK
13. When the driver is updated you will be prompted to reboot your system.
Reboot and everything should work fine.
Do you have Plug and Play enabled?
Another likely cause of problems is that your motherboard may not have a Plug-and-
Play-capable BIOS and your Plug and Play SCSI interface board is not Plug-and-
Play-compliant. To solve this problem:
1. Restart your computer.
2. Check your motherboard BIOS (CMOS) to confirm that Plug and Play is
enabled. If it is disabled then enable Plug and Play.
3. If either your motherboard or your SCSI interface board does not support Plug
and Play, review the hardware installation procedures beginning on page 11 of
this manual. Make sure termination is set properly on your interface board and all
devices attached to it.
4. Restart your computer.
Do you have a SCSI ID conflict?
In this case, you simply need to deal with SCSI ID selection, as follows:
1.
Turn off your computer.
2. Review the discussion of SCSI ID selection in your drive’s operation manual.
3. Check the physical selection of SCSI ID on your PlexWriter drive and any other
SCSI devices connected to your interface board. Make sure that all devices are
physically set to unique IDs.
4. Your board also may not have automatic termination. If it does not have
automatic termination, you will also need to make sure the termination of your
board is set properly.
!
If you have both internal and external devices attached, the termination on
your SCSI interface board should be disabled. Review the interface board's
documentation to determine how to do this.
!
If you have only internal devices, or only external devices, termination of
your SCSI interface board should remain enabled.
5. After the SCSI IDs and termination are set properly, restart your system.