PX-65CS External Drive----
REAR PANEL
➊
SCSI ID:
Use this dial to designate SCSI ID number. Rotate the dial to change the
number. If you are using more than one SCSI peripheral, you may need to change
your SCSI ID number (see pages 15 and 16).
➋
DIP Switches:
Use to set parity, term, test, block size and eject lock options. Leave
these switches at their factory settings unless either or both of the following situations
pertain to you:
Term:
Review Chapter 7 to determine if you need to turn your terminator switch
off.
Block size:
If you are working in a UNIX environment and want to boot from your
CD-ROM drive, see page 17.
Eject Lock:
If you work in an environment where you need to prevent others from
removing a CD-ROM disc from your drive, see page 17.
➌
AC Power Input:
Use the power cord supplied with your drive.
➍
SCSI Interface Connector I and II:
One connector should be used to link your
CD-ROM drive to your SCSI host adapter; the other to link your CD-ROM drive to
another SCSI peripheral with a daisy chain cable (see page 31). You may use either
connector for either purpose.
➎
Audio Output:
Outputs stereo analog signal via RCA jacks. Use to connect to
audio amplifier or other audio equipment.
➊
SCSI ID
➌
AC Power Input
➍
SCSI Interface
Connector I and II
➎
Audio
Output
(RCA jacks)
➋
DIP Switches
CHAPTER 5 ---- Drive Features
12
PX-63CS/PX-65CS OPERATION MANUAL
