ID set to 4. The rotary dial and DIP switches are set by the factory as
shown below:
Changing the SCSI ID
Using the blade of a screwdriver, rotate the dial’s arrow to a different SCSI ID number.
Other Switch/Jumper Settings----
PX-R412CSi/PX-R412CSe
The remaining switches (external drives) and jumpers (internal drives) are:
Parity
Leave this ON. The parity check provided by the ON setting enhances the
reliability of the SCSI bus. Set to OFF only if your computer system or SCSI
controller specifically requests that parity be disabled.
Term
This enables or disables (turns ON or OFF) SCSI termination. Factory setting
is enabled (ON). See page 19 for an explanation of SCSI termination and to
determine if you need to change this setting.
Test
Leave this OFF. It is for factory use only.
Block
Leave this OFF, unless you are working in a UNIX environment and want
to boot from your CD-ROM drive. If so, set this switch/jumper ON.
cross-ref.
CHAPTER 6 ---- Drive Switch/Jumper/Dial Settings
SCSI ID
FLASH
(OFF) O
(ON) l
TERM
PARITY
BLOCK
SIZE
TEST
5.75" x 8.25" PLEX WRITER MANUAL
Plextor manual, Carla Williams
1/2/98
18
PX-R412CS OPERATION MANUAL
