PX-R412CSi Internal Drive
Factory Setting of Jumper Block
The functions shown are ON if the jumpers are installed and OFF if jumpers are
removed. The jumpers are set by the factory as follows:
Installing and Removing Jumpers
Ensure power to the drive is OFF before installing or removing jumpers.
To remove a jumper, pull it off with your fingers or a pair of needle-nose pliers.
To add a jumper, push it onto the jumper pins. Extra jumpers are supplied with the
PX-R412CSi in addition to the three jumpers already installed at the factory.
Caution:
Install jumpers
across
each pin as shown. Do
not
connect one pin switch
to another by installing the jumpers lengthwise. Doing so could result in
damage to the drive.
ONLY
when upgrading firmware are jumpers
connected lengthwise.
Install Jumpers This Way Do
NOT
Install Jumpers This Way
(Except when upgrading firmware.
See following section.)
PARITY
Jumper
CHAPTER 6 ---- Drive Switch/Jumper/Dial Settings
On (Jumper installed)
Off (Jumper removed)
TEST
FLASH
SCSI-ID
TERM
BLOCK SIZE
5.75" x 8.25" PLEX WRITER MANUAL
Plextor manual, Carla Williams
1/2/98
14
PX-R412CS OPERATION MANUAL
