Installation Instructions
Model XX0705
PA1361
Page 7 of 10
Notes Before You Begin:
Do not over tighten bolts during assembly, only snug
tighten them until assembly is complete.
Carefully read and understand these installation instructions before you
begin.
Step 1:
Before attempting to assemble your equipment, please review all
installation information carefully. Should you experience any diffi culty during the
installation process, please call us at the phone number shown on the last page
of these instructions.
Step 2:
Separate and identify all components and hardware.
Step 3:
Attach the belts to the Father and Mother frames. See
Details A-1
through A5 and Belts Placement Reference
. Place a cover casting onto each
end of the Father to Mother belts. Ensure the curved side of the casting is facing
the frame bracket. Insert the end of each belt into the appropriate bracket on the
Father and Mother frames. Apply a drop of thread locking adhesive to the bolt
threads and attach the end of the belts to the
underside
of the frame brackets as
shown.
Apply a drop of thread locking adhesive to the bolt threads and attach the
end of the belts to the top side of the frame brackets as shown. Fully tighten the
connections, both underneath and on top of the bracket, according to tightening
torque specifi cations. Slide the cover casting over top of the frame bracket, apply
a drop of thread locking adhesive to the bolt threads and attach as shown. Fully
tighten those connections according to tightening torque specifi cations.
Torque Specifi cations:
Bolts and nuts
- Snug tighten and then tighten an additional one half turn.
Step 4:
Attach the belt handles to the belts. See
Detail B
. Position each handle
onto the edge of the belt and align with the set of holes along the side of the belt
and attach as shown. Fully tighten the connections according to tightening torque
specifi cations.
Step 5:
Attach the rope castings to the ends of the Father To Mother rope. See
Detail C
. Remove the frox balls from the ends of the rope. Balls are grooved and
will slide apart. Insert the each end of the ropes through a casting and reattach the
frox balls. Pull the rope tight in the casting, apply a drop of thread locking adhesive
to the bolt threads and attach the rope cap plate to the casting as shown. Fully
tighten the connections according to tightening torque specifi cations.
Step 6:
Attach the Father to Mother rope to the Father and Mother frames. See
Detail D and Rope Placement Reference
. Position the rope castings against
the Father and Mother frames, apply a drop of thread locking adhesive to the
bolt threads and attach as shown. Fully tighten those connections according to
tightening torque specifi cations.