PLAYSTAR LEGACY PS 73161, Инструкция по безопасности и руководство по сборке

Страница: 42 / 44

42
CLIMBING WALL – Assembly Instructions
1. Align top of Climbing Wall at right angle (90˚). Lip of
climbing wall should rest on the 2" x 4"
mounted
12" below the play deck 1
¹₂
". Using the Climbing
Wall as a template, mark play deck through the
three holes in the climbing wall. Drill three
¹⁄₈
" holes
at marked locations.
(Fig. 1)
2. Attach Climbing Wall temporarily to play deck with
three #14 x 1
¹⁄₄
" pan head screws provided.
3. Prepare level area where Climbing Wall touches
ground.
4. Locate and mark the ground on the back side and
`in center of Climbing Wall. Remove Climbing Wall
and screw Playset Anchor into the ground (a long
screwdriver will help). Screw the anchor deep
enough so that the center of the loop at the top of
the anchor will be approximately 3
¹₂
" off ground
when wall is in the final position.
5. Reinstall Climbing Wall permanently, attaching it to
play deck using #14 x 1
¹₄
" pan head screws provided.
6. Use the anchor as a drill guide and drill a
³₈
" hole
completely through the Climbing Wall. Attach
Climbing Wall to anchor with one
³₈
" x 1
¹⁄₄
" hex bolt,
two
³₈
" washers and one
³₈
" lock nut provided in the
anchor kit.
(Fig. 2)
Warning: Failure to anchor the Climbing Wall
properly could cause serious injury from
3
¹|₂
"
Fig. 2
CLIMBING STEPS – Assembly Instructions
Fig. 3
12"
Position the Climbing Steps Assembly into the
21
¹⁄₂
" opening of your play deck so that the top
surface of the top step is 12" from the top
surface of your play deck (48" from the
ground). Secure the Climbing Step Assembly
to the play deck using three #14 x 1
¹⁄₄
" pan
head screws on each side as shown.
(Fig. 3)
NOTE: The steps must be positioned as
specified. The gaps must not exceed
3
¹⁄₂
" otherwise a head entrapment
could exist.
1
¹|₂
"
Fig. 1
anchor location