20
Cable Faults
Description
Up/Down
The Up/Down buttons allow you to adjust the cable length
within the range of 10 m – 300 m or 25 ft to 1000 ft.
▪
Press the UP and DOWN buttons to increment or
decrement the length.
▪
Press and hold the UP or DOWN button to quickly
increase or decrease the cable length.
Calibration
Press the CAL button to increase cable length in 50 ft or
20 m increments according to the unit of measurement
selected (feet or meters).
Table 10.
Adjusting Cable Length.
4. Verify the Snap Shot™ is set to your desired unit of measurement (feet
or meters). To change the unit of measurement, press and hold down
the MEM and CAL buttons simultaneously for two seconds. The unit of
measurement will adjust in the LCD display screen.
5.
Enter the length of the attached cable. See Table 10 for a description of
how to adjust cable length using the Up/Down and Calibration buttons.
Note:
Once the maximum length (1,000 ft or 300 m) is reached
through use of the CAL button, a subsequent press of the
button adjusts the cable length to the default cable length (50
ft or 20 m).
To abort Calibration Mode and retain your previous inputted
cable length, press and hold down the CAL button. The unit
defaults to Test Mode.
6. Press the TEST mode button. The following updates occur in the LCD
display screen (see Figure 6):
▪
The three dashes in the lower left corner disappear. The calcu-
lated NVP value for the inputted cable length appears in place
of the three dashes.
▪
The cable length displays in the upper right corner.
▪
The Memory Storage location last selected (M1 or M2) appears
above the NVP value.
▪
The adjustment indicator icon appears in the lower left corner.
▪
The “Open” icon displays as Calibration Mode is used with
unterminated cables only.
