Planmeca PlanMill 40 S, Руководство пользователя, Страница: 4 / 32

PlanMill 40 S Introduction
Indications for Use
The PlanMill 40 S is a dental milling machine used to fabricate restorations from compatible dental materials.
Startup Procedure
Press the green button on the front of the mill to turn it ON.
When the mill software loads, the initializing screen appears. Close the lid firmly and wait for the software to automatically load.
Lid Lights
The lid lights change color based on the status of the mill.
Lid Color Description
Blue (solid) Mill is initializing
Green (solid) Mill is idle or is milling. It can accept instructions (select restorations, cancel
milling, replace tools, etc.)
Green (flashing) Milling complete. The restoration has completed milling and the lid is open.
Red (flashing)
The mill has faulted. Warning screen: Re-initialize to clear the fault or enter
the diagnostic state to attempt to diagnose the problem.
White Lid is open.
Yellow Warning message displayed.
Shutdown Procedure
The mill should remain ON during the week. Turn it OFF at the end of the week.
1 Touch the X in the top-right corner of the display. A verification screen appears, touch OK.
2 Close the lid if it is open. The lid stays closed while the mill runs its closing procedure. The lid opens automatically, leave the lid
open.
The desktop for the operating system (Windows) appears.
3 Ensure that all mill motor movement has stopped.
Press and hold down the green power button for approximately 10
seconds. This process will prompt the operating system (Windows) to shut down.
The screen and red button will go dark.
Relocating the Mill
Warning:
The mill weighs approximately 170 lb. (77 kg). Always follow these guidelines when relocating the machine.
When relocating the mill, remove the tank from the machine.
The Mill is designed to operate on a level and stable surface in an environment free from excessive moisture or dust. When
choosing a location for the mill, adhere to all clearance requirements stated in System Specifications.
1 Ensure no milling operations are in progress.
2
Open the front access panel and remove the fluid reservoir.
3
Empty the fluid reservoir according to your approved material disposal protocols.
Planmeca PlanMill 40 S User Manual PlanMill 40 S Introduction 4