Planet WAP-2000, Руководство пользователя, Страница: 28 / 35

-24-
Chapter 4 Troubleshooting
If you have trouble using the 11Mbps Wireless LAN Access Point, the starting point to
troubleshoot the problem with your Access Point is looking at the LED activity of the Access
Point. The following is “LED Error Table” provided to assist you in diagnosing and solving
operational problems.
PWR AP WLAN LAN LINK Description/Action
Steady
Green
Continuous
Green
Flash
Green
Flash
Green
-
Normal operation where flickering
indicates interface activity.
No action required.
Continuous
Green
On Off Off -
Normal operation that indicates
there is no LAN activity.
No action required.
Off Off Off Off Off
Power failure.
Check the power cord.
Check the power supply.
Off Off Off Off
Invalid loader firmware or the
micro-controller is dead.
Return the unit to the vendor for
support.
Blink Green - - -
Invalid Access Point firmware.
Upgrade the firmware via the
utility or console mode.
Blink Green
Blink
Green
- -
Wireless LAN initialization failure
Check whether the wireless
module has been properly installed.
Continuous
Green
Blink Green -
Blink
Green
-
Ethernet initialization failure
Return the device to the vendor
for support.
If you are still unable to solve the problem by checking the LED activity, the error may be
caused from configuration mismatch, which prevents the Access Point from establishing a
wireless connection with the network. You may check the following to ensure normal
operation of the Access Point.
n
WEP keys: If data encryption is activated, always remember to set WEP keys exactly the
same on the Access Point as are on the wireless stations.