Planet WAP-2000, Руководство пользователя, Страница: 24 / 35

-20-
To change factory default settings, type “set xxx (parameter) xxxx (value). For example,
set channel 7
command will set the channel to number 7;
set essid “Your
Network”
command will set the ESSID as Your Network . Remember that, a 'save'
command is required for changes to take effect. Always reset your AP with the “Reset”
command.
The following is a list of parameters you can make changes on the Access Point.
Parameter Description Default Value
apname A textual name for the identification of the Access
Point.
apXXXXXX
(where XXXXXX is the
last six octets of Access
Point’ s MAC address)
channel The radio channel number.
1
essid The ESS ID (a.k.a., SSID) of the Access Point.
My Network
rts_threshold The threshold (number of bytes) for enabling RTS/CTS
handshake. Data with its frame size larger than this
value will perform the RTS/CTS handshake. Range of
value: 0~2432.
2432
frag_threshold The threshold (number of bytes) for the fragmentation
boundary. Data will be transmitted in fragments which
its size does not exceed this value. Range of value:
256~2432.
2432
ip_address The IP address of the Access Point.
192.168.1.1
ip_netmask The subnet mask address of the Access Point. 255.255.255.0
ip_gateway The default gateway address of the Access Point.
192.168.1.254