The following table describes the parameters and buttons of this page:
Field
Description
IP QoS
Select to enable or disable IP QoS function. You need to enable IP
QoS if you want to configure the parameters of this page.
QoS Policy
You can choose
stream based
,
802.1p based
, or
DSCP based
.
Schedule Mode
You can choose
strict prior
or
WFQ (4:3:2:1)
.
Src IP
The IP address of the source data packet.
Src Mask
The subnet mask of the source IP address.
Dest IP
The IP address of the destination data packet.
Dest Mask
The subnet mask of the destination IP address.
Src Port
The port of the source data packet.
Dest Port
The port of the destination data packet.
Protocol
The protocol responds to the IP QoS rules. You can choose
TCP
,
UDP
, or
ICMP
.
Phy Port
The LAN interface responds to the IP QoS rules.
Set priority
The priority of the IP QoS rules. P0 is the highest priority and P3 is
the lowest.
IP Precedence
You can choose from 0 to 7 define the priority in the ToS of the IP
data packet.
IP ToS
The type of IP ToS for classifying the data package
You can choose
Normal Service
,
Minimize Cost
,
Maximize
Reliability
,
Maximize Throughput
,
or
Minimize Delay
.
802.1p
You can choose from 0 to 7.
delete
Select a row in the
QoS rule list
and click it
to delete the row.
delete all
Select all the rows in the
QoS rule list
and click it
to delete the rows.
3.6.5 SNMP
Choose
Advance
>
SNMP
, the page shown in the following figure appears. You can
configure the SNMP parameters.
67
