ecliPse sHaft4 barrel
a
b
d
c
e
4
The Eclipse Geo2 comes as standard with an Eclipse Shaft 4 barrel.
1
The barrel screws into the body of the Geo2 using a right hand thread
meaning that if you
hold the Geo2 pointing away from you the barrel screws into the body in a counter-clockwise
direction.
2
The barrel comprises of two parts, a barrel back and a barrel front . The two parts are
joined together with a
left hand thread meaning that if you hold the barrel, with the back
nearest you, the front unscrews in a counter-clockwise direction. The bore size of the barrel
back is engraved at the end of the barrel back .
3
On the barrel back there is a 016 Nbr 70 o-ring which prevents the barrel from vibrating
loose from the Geo2 body when the marker is fired. There is also a 015 Nbr 70 o-ring on the
tip of the barrel back helps with alignment when the two sections are screwed together.
replace and lubricate these o-rings with Eclipse Grease as necessary.
e
d
c
b
a
1
The bore size of your Shaft4 may vary according to
the model of Geo2 you have.
2
The Geo2 will only accept COCKER Threaded barrels.
Do not use any other type of barrel thread.
3
The Eclipse Shaft4 front and back barrel sections are
not interchangeable with older version shaft front
and back barrel sections (including Shaft3 barrel kits).
4
The model of barrel accompanying your Geo2 may
differ from above.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
7.
ORIENT
ATION
ORIENTATION
QuicK Guide