(continued)
Clean off any dirt, debris, paint or grease from the
Spool Pack and inspect the o-rings for signs of wear or
damage
(see fiGure 13.14)
. if any of the o-rings on the
Spool Pack are damaged replace the entire spool pack.
Using a dry Q-tip clean the inside of the manifold where
the Spool Pack resides ensuring that any dirt, debris and
old grease is removed
(see fiGure 13.15)
. lubricate every
o-ring on the outside of the Spool Pack thoroughly with
Eclipse Grease and insert the Spool Pack into the manifold
making sure that the screw hole in the end lines up with
the hole in the manifold
(see fiGure 13.16).
Using an appropriate sized Phillips head screwdriver,
replace and tighten the Spool Pack retaining screw into
the manifold
(see fiGure 13.17).
hold the Solenoid Assembly onto the bottom of the Geo2
body, taking care to line it up correctly with the screw
holes in the body and to avoid pinching the bbSS wires
underneath it
(see fiGure 13.18)
. Use a 5/64” hex key to
tighten the two screws that hold the Solenoid Assembly
onto the Geo2 body
(see fiGure 13.19).
1
you have now successfully stripped and cleaned your Geo2
Solenoid Assembly.
1
DO NOT over tighten screws in the Solenoid Assembly.
WarninG: if You are at all unsure at PerforminG
tHe maintenance Procedure Please contact Your
nearest ecliPse serVice centre. (see PaGe 69)
fiG 13.16
fiG 13.17
fiG 13.18
fiG 13.19
fiG 13.14
fiG 13.15
60.
m
AINTENANCE