(continued)
Clean and check the condition of the single internal
005 Nbr90 o-ring in the front of the POPS insert, replace if
necessary
(see fiGure 15.9)
. lubricate this o-ring liberally
using Eclipse Grease.
lubricate the narrow end of the POPS Pin with a smear
of Eclipse Grease and push the Pin, narrow end first, into
the POPS insert so that it sits in the POPS insert and pokes
through to the front
(see fiGures 15.10 & 15.11)
.
Screw the POPS insert back into the POPS body ensuring
that the o-ring end goes in first
(see fiGure 15.7)
.
replace the Push rod into its designated slot
(see fiGure
15.12)
, then side a 004 Nbr70 O-rings on both ends of the
Push rod. Make sure the Push rod is centred in the POPS
body
(see fiGure 15.13)
.
Slide the bonnet over the POPS body and align the hole
on the bonnet with the front hole on the POPS body
(see
fiGure 15.14)
.
Ensure the latch button and Spring are attached to each
other then slide them both into the POPS body through the
hole in the bonnet, spring end first, making sure the latch
button pokes out the right side of the bonnet
(see fiGure
15.15)
.
Push the button down as far as it will go, then (while still
holding down the button) slide the bonnet back until the
button engages with the POPS body and cannot slide into
the forward position
(see fiGure 15.16)
. reconnect the
Macroline hose to the fitting on the POPS body.
you have now successfully cleaned and maintained your
Push Operated Purge System.
WarninG: if You are at all unsure at PerforminG
tHe maintenance Procedure Please contact Your
nearest ecliPse serVice centre. (see PaGe 69)
fiG 15.10
fiG 15.12
fiG 15.14
fiG 15.16
fiG 15.9
fiG 15.11
fiG 15.13
fiG 15.15
64.
m
AINTENANCE