tHe sound indicator
The sound indicator on the run screen is used to convey if
the
SOUND
parameter in the
HARDWARE
menu (page 41) is
switched on or off.
There are two possible conditions that can be indicated:
in order for the trigger to be successfully operated it must
first be released and then pulled. The trigger detection
indicator (TDi) is used to indicate each of the possible
trigger states.
From the factory the Geo2 will have the Opto sensor
enabled. The micro-switch option can be selected by
referring to the
HARDWARE
menu
(see page 41).
tHe triGGer detection
indicator (tdi)
sound enabled
The
SOUND
parameter is enabled. The Geo2
will make sounds when switched on and off
and when the game timer alarms or times out.
sound disabled
The
SOUND
parameter is disabled. The Geo2
will not make any sounds.
micro-sWitcH selected, not
actuated
The Geo2 is configured to use the micro-switch
to detect trigger pulls. The micro-switch is not
currently actuated, i.e. the trigger is released.
micro-sWitcH selected, actuated
The Geo2 is configured to use the micro-
switch to detect trigger pulls. The micro-switch
is currently actuated, i.e. the trigger is pulled.
oPto sensor selected, readinG
aboVe Pull Point
The Geo2 is configured to use the Opto sensor
to detect trigger pulls. The Opto sensor is
currently reading above the Opto pull point,
i.e. the trigger is considered ‘pulled’.
oPto sensor selected, readinG 0%
The Geo2 is configured to use the Opto
sensor to detect trigger pulls. The Opto sensor
is currently reading 0%, i.e. the trigger is fully
released.
oPto sensor selected, readinG
100%
The Geo2 is configured to use the Opto sensor
to detect trigger pulls. The Opto sensor is
currently reading 100%, i.e. the trigger is fully
depressed.
oPto sensor selected, readinG
beloW release Point
The Geo2 is configured to use the Opto sensor
to detect trigger pulls. The Opto sensor is
currently reading below the Opto release
point, i.e. the trigger is considered ‘released’.
oPto sensor selected, readinG
mid-ranGe
The Geo2 is configured to use the Opto sensor
to detect trigger pulls. The Opto sensor is
currently reading somewhere between the
Opto release point and the Opto pull point, i.e.
the trigger is half depressed.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
25.
USING
y
OUR
GEO
2
USING YOUR GEO2
QuicK Guide