27
4.
When you unpack the appliance, you should take note of the position of every
part of the interior accessories in case you have to repack and transport it at a
later point of time.
5.
Do not operate the appliance unless all components are installed properly.
6.
Do not stand or lean on the base, the drawers, the doors etc of the appliance.
7.
The air vents of the appliance or its built-in structure (if the appliance is
suitable for being built-in) must be completely open, unblocked and free of any
kind of dirt.
8.
Remove all fluffs before operating the appliance.
9.
Never dry unwashed laundry.
10.
When you use fabric conditioner or a similar product, observe the information
given on their packaging.
11.
Dry dryer-proof fabrics only. Observe the information on the labels.
12.
If you install the appliance on a carpet or carpeted floor, ensure proper air
circulation by adjusting the adjustable feet.
13.
Do not place any items liquid can escape from on the appliance as the liquid can
damage the control panel.
14.
Metal-made items, e.g. keys, screws, coins etc., can damage the appliance. Check
that your laundry is free of such items.
15.
Do not overload the appliance.
16.
Do not put dripping-wet laundry in the appliance.
17.
The room temperature should not be less than +5 °C and not more than +35°C
when operating the appliance.
18.
Clean the filter after operating the appliance.
2
INSTALLATION
2
Unpacking and positioning
1.
Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2.
Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3.
Check that the appliance and the power cord are not visible damaged.
4.
Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
5.
Install the appliance on a
level, dry and solid floor
. Check the correct
installation with a bubble level.
6.
Remove the complete packaging material ( inside and outside the appliance)
before initial operation.
7.
The nameplate is situated inside the appliance or at the back.
