M0158B ITEN
46
/56
Installation, use and maintenance
7 LONG RESET KEY KEYING
K900 is informed that the calibration procedure is finished.
Before performing this operation, make sure the indicated value is that required
8 NO OPERATION
At the end of the calculation, the new USER K FACTOR is shown for a few sec-
onds, after which the restart cycle is repeated to finally achieve standby condition.
IMPORTANT: From now on, the indicated factor will become the calibration factor
used by the meter and will continue to remain such even after a battery change
9 NO OPERATION
K900 stores the new calibration factor and is ready
for dispensing, applying the newly defined USER K FACTOR.
9 CONFIGURATION
K900 has a menu with which the user can configure the machine in accordance with his/her requirements.
To enter the configuration menu, proceed as follows:
1
wait until K900 is in Stand-by
2
press the CAL and RESET buttons at the same time and hold them down until the
word “Unit” and the previously-set unit of measurement appear on the display (Litre/
Litre in this example)
CAL
CAL
CAL
RESET
RESET
RESET
Содержание K900
Страница 27: ...M0158B ITEN 54 56 Installation use and maintenance ...
Страница 28: ......
Страница 29: ...Bulletin M0158B itEN _03 10 2022 ...