Piusi K900, Инструкция по установке и использованию

Страница: 12 / 29

39
/124
39
/56
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Translated from Italian
6.1.1 PARTIAL RESET (NORMAL MODE)
The partial register can be reset by pressing the reset key when the meter is in
standby, meaning when the display screen shows the word “TOTAL”.
After pressing the reset key, during reset, the display screen first of all shows all the
lit-up digits and then all the digits that are not lit up.
At the end of the process, a display page is first of all shown with the reset partial
and the reset total
and, after a few moments, the reset total is replaced by the non resettableTotal.
6.2 RESETTING THE RESET TOTAL
The reset total resetting operation can only be performed after resetting the
partial register. The reset total can in fact be reset by pressing the reset key at
length while the display screen shows reset total as on the following display
page:
Schematically, the steps to be taken are:
1
Wait for the display to show normal standby display page (with total only
displayed)
2 Press the reset key quickly
3 The meter starts to reset the partial
4
While the display page showing the reset total is displayed
Press the reset key again for at least 1 second
5 The display screen again shows all the segments of the display followed by all
the switched-off segments and finally shows the display page where the reset
Reset Total is shown.