M0158B ITEN
38
/56
Installation, use and maintenance
6
DAILY USE
FOREWORD
The only operations that need to be done for daily use are partial and/or resettable total reg-
ister resetting. The user should use only the dispensing system of K900. Occasionally the
meter may need to be configured or calibrated. To do so, please refer to the relevant chapters.
Below are the two typical normal operation displays. One display page shows the partial and reset total reg-
isters. The other shows the partial and general total. Switchover from resettable total to general total display is
automatic and tied to phases and times that are in factory set and cannot be changed.
•
The Partial register positioned in the top part of the display indicates the quantity
dispensed since the RESET key was last pressed
•
The RESET Total register, positioned in the lower part of the display, indicates the
quantity dispensed since the last RESET Total resetting. The RESET Total cannot be
reset until the Partial has been reset, while vice versa, the Partial can always be reset
without resetting the RESET Total. The unit of measurement of the two Totals can
be the same as the Partial or else different according to the factory or user settings.
•
The General TOTAL register (Total) can never be reset by the user. It continues to rise
for the entire operating life of the meter.
•
The register of the two totals (Reset Total and Total) share the same area and digits of
the display. For this reason, the two totals will never be visible at the same time, but will
always be displayed alternately.
•
The General Total (Total ) is shown during Meter standby
•
The Reset Total is shown:
- At the end of a Partial reset for a certain time (a few seconds)
- During the entire dispensing stage
- For a few seconds after the end of dispensing. Once this short time has expired. Meter
switches to standby and lower register display switches to General Total
NOTE
6 digits are available for Totals, plus two icons x 10 / x100. The increment se-
quence is the following:
0.0 -> 99999.9 -> 999999 -> 100000 x 10 -> 999999 x 10 ->100000 x 100 -> 999999 x 100
6.1 DISPENSING IN NORMAL MODE
FOREWORD
Normal mode is the standard dispensing. While the count is made, the partial and resettable total are
displayed at the same time (reset total).
WARNING
Should one of the keys be accidentally pressed during dispensing, this will have no ef-
fect.
stand by
A few seconds after dispensing has ended, on the lower register, the display switches from reset-
table total to general total: the word reset above the word total disappears, and the reset total is
replaced by the general total.
This situation is called standby and remains stable until the user operates the K400 again.
Содержание K900
Страница 27: ...M0158B ITEN 54 56 Installation use and maintenance ...
Страница 28: ......
Страница 29: ...Bulletin M0158B itEN _03 10 2022 ...