Page 3
For technical questions, please call 1-888-866-5797.
Item 69259
14. The warnings, precautions, and instructions
discussed in this instruction manual
cannot cover all possible conditions
and situations that may occur. It must
be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE
INSTRUCTIONS.
SPECIFICATIONS
Laser Range
Projects Up to 1500 ft.
Max. Tripod Height
42″
Swivel Head Range
360°
Batteries
(2) AAA (included)
LASER LIGHT
AVOID DIRECT EYE EXPOSURE
Max. Output: 3 - 5 mW,
Wavelength: 635 - 670 nm
CLASS II LASER PRODUCT
This product complies with
21 CFR 1040.10 and 1040.11
Distributed by Harbor Freight Tools
3491 Mission Oaks Blvd.
Camarillo, CA 93011
69259
Manufacture Date: ___________, _______
UNPACKING
When unpacking, make sure that the is
intact and undamaged. If any parts are missing
or broken, please call Harbor Freight Tools
at 1-888-866-5797 as soon as possible.
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including all
text under subheadings therein before set up
or use of this product.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch to Off
before adjusting Laser Level.
Note:
For additional information regarding the
parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
Assembly
1. Your Laser Level will require some
assembly prior to use. Read entire
manual to become familiar with product
BEFORE you use the Laser Level. Be
sure you have all parts described in
the Parts List and Assembly Diagram
located on the last page of this manual.
2. Unfold Tripod (15) by pulling out on the
Tripod arms. Turn the Knob (17) to lock
the arms in place. See Figure 1, below.
Tripod
(15
)
Figure 1
Knob (17)
Latch
Arms
3. The legs of the Tripod can be raised or
lowered by lifting the latch on the body
of the Tripod and sliding the leg in or out
to the desired height. Push the latch
down into place to Lock the Leg in place.
Repeat for the remaining two legs.
4. Set the Tripod on a flat surface. Once
the Tripod (15) is set up, you can raise
and lower the Rotating Head (7) by
turning the Handle (18) located at the
top of the Tripod. See Figure 2, below.
Handle (18)
Rotating
Head (7)
Tripod
(15
)
Figure 2
5. Wind the Handle clockwise to raise the
Rotating Head and counterclockwise
to lower the Rotating Head.
6. Set the Body (5) into the slot in the
Tripod. See Figure 3, below. Tighten
