Page 5
For technical questions, please call 1-888-866-5797.
Item 69259
6. Once Laser Level is set in Tripod, you may
set the laser to the type of beam you wish
to use. The laser projects up to 1,500
feet. Set the Lens Fixture (11) “Down”; and
this mode will fix the Level Laser beam
to a beam splitter (-) mode. The beam
splitter mode will project a horizontal line.
Set the Lens Fixture (11) to the top mode
and this mode will set the Laser Level
beam to a dot. Turn the Laser Level “ON”
by pressing the “ON/OFF” button (9).
7.
WARNING! Do not point the Laser
Level at people or animals.
8. Once you have leveled the Level Laser in
the Tripod (15), you can use it for many
applications. Rotating the Rotating Head
(7) with the laser ON and set to the beam
splitter (-) mode, you can set a line of
equal height in a room to verify alignment
of pictures, electrical plugs, or shelving.
The Laser Level can also be used to set
a level for any surface while providing a
bright beam to mark your settings by.
MAINTENANCE AND SERVICING
Procedures not specifically
explained in this manual
must be performed only by
a qualified technician.
TO PREVENT SERIOUS
INJURY FROM
ACCIDENTAL OPERATION:
Turn the OFF the Laser Level
before performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Installing and Removing Batteries
1. Remove the Battery Cover (13)
located under the On/Off Button (9).
See Figure 7, below.
Figure 7
Battery Cover
(13)
2. The Laser Level uses two (2) “AAA”
batteries. Remove the old batteries
and insert two new batteries.
See Figure 8, below.
Figure 8
“AAA”
Batteries
3.
WARNING!
Verify batteries are inserted
according to indicated polarity (so that
positive and negative ends match the
diagram on the end of the Laser Level).
