Pitney Bowes SHG7, Руководство оператора

Страница: 6 / 20

SV62931 Rev. C | Operator Guide
6 | SHG7 Cross-Cut Shredder
System Power Notes
• Use the power cord supplied with the machine chassis at the power entry and plug it into a
properly grounded (earthed) and easily accessible wall outlet located near the machine. Failure
to properly ground (earth) the machine can result in severe personal injury and/or fire.
• The power cord wall plug is the primary means of disconnecting the machine from AC power
supply for Lock Out/Tag Out.
• DO NOT use an adapter plug on the line cord or wall outlet.
• DO NOT remove the ground pin from the line cord.
• The machine will be connected to a dedicated 20 Amp AC power line. A 20 Amp receptacle is
shown. DO NOT route the power cord over sharp edges or trap it between furniture.
• Ensure there is no strain on the power cord where it becomes jammed between the equipment,
walls or furniture.
• Be certain the area in front of the wall receptacle into which the machine is plugged is free from
obstruction.
• Ensure there is no strain on the power cord where it becomes jammed between the equipment,
walls or furniture.
• For Input modules and Output modules - power is distributed from the chassis. Use the AC
connectors supplied with the modules to connect to system power. Do not connect external
devices to the inserter.
Compliance Information
United States
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult Pitney Bowes Service or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.