Pitney Bowes SHG7, Руководство оператора

Страница: 18 / 20

SV62931 Rev. C | Operator Guide
18 | SHG7 Cross-Cut Shredder
Troubleshooting
Motor Overload
Should the motor be overloaded it switches off. The control display (9) comes on.
The machine can be started again after a cooling down period of about 15 – 20 minutes (depending
on the model and the room temperature).
Material Jam
When too much material is being fed in the feed slot, the cutters jam, run in reverse for a short time
(material is released), and stop. The motor turns off and the operation error icon lights up. To fix:
Paper
1. Remove the paper that has been fed back.
2. The cutter starts running forwards automatically and shreds the remaining paper.
3. Continue shredding with less paper.
Material Sensors Blocked When Collection Bin Opened
If there is material in the feed slot when the collection bin is opened, the motor turns off and the
cutters stop. The operation error icon lights up.
Push in the bin and press the forward button briefly. The existing material is fed to the cutters and
shredded.
Electrical Fault
If the motor/electrical fault icon flashes together with the ON/Sleep/Stop button being lit, or
only the collection bin open/fault icon flashes, there is an electrical fault. The machine cannot be
started. Please contact Pitney Bowes Service.
Check List
If the machine isn’t working, check the following:
□ Is the plug connected to the AC outlet?
□ Is the operator interlock enabled?
□ Is the collection bin properly pushed in?
□ Is the collection bin full?
□ Is there a material jam in the machine?
□ Is there a motor overload condition?
If you can’t resolve the issue, contact Pitney Bowes Service.