Pitney Bowes relay 2000, Руководство оператора

Страница: 31 / 92

Program a Job • 2
2-13 SV63139 Rev. A
Run a Trial Piece
Run a trial piece to test the job settings.
1. Load material and press
Trial Piece .
2. If you need to make changes to the settings based on the trial piece:
a. Press Setup .
b. Log in with Supervisor access level.
c. Press
Prev
(◄),
Next
(►) to scroll to the setting you wish to
modify.
d. Press Change ( +/- ) to scroll to the desired option.
3. Press Setup to accept the setting modification and return to run mode.
The inserter saves the job with the new settings.
4. Run another trial piece to test the modified settings.
NOTE: Any time you modify settings you must run a trial piece.
Incorrect Address Position - Adjust Fold Settings
When you run a trial piece, if the address is not in the correct position refer
to the Adjust Fold Settings table to help you fine tune your folds settings.
Adjust Fold Settings Table
Fold Type Address Too Low Address Too High
C - Letter Fold Decrease Fold A Increase Fold A and
increase Fold B by the
same amount.
Double Fold Decrease Fold A Increase Fold A
It is recommended the fold is only adjusted by 0.20 inches (5mm) each time.