Pitney Bowes OptiFlow DIVS, Руководство оператора

Страница: 18 / 24

OptiFlow™ Vertical Power Stacker
1 SV61322 Rev. C
Stacker Operation in Non-Communicating Mode
(DI380/DI425 and DI500/600 Only)
The stacker is designed to communicate with your Pitney Bowes
inserter by means of a serial connection.
This is called an "intelligent" interface; it allows sensors in the stacker
to monitor mail piece flow so that when the stacker fills up or a mail
piece stalls, the inserter stops automatically.
If the "Stacker not Detected" or “E108-Power Stacker Not Detected”
error displays on DI380/DI425 or DI500/DI600 inserters, respectively,
check the serial cable (page 3) that connects the inserter and stack-
er. Try resetting the stacker (page 3), then press START. If this fails
to correct the problem, you may run the stacker in non-communicat-
ing mode.
Select "Uninstall Stacker" (an option on the inserter display that ap-
pears with the error message). The error message will not occur
again. The stacker is now in non-communicating mode; you can run
it this way as a temporary measure until Pitney Bowes service can
resolve the problem.
IMPORTANT:
Please note the following when you run the stacker in
non-communicating mode:
• No error messages will be sent to the inserter regarding the
stacker. If a stalled mail piece or stack-full condition occurs, the
inserter will continue to feed mail into the stacker and create
more stalled mail pieces, eventually stopping the inserter.
• You must empty the stacker more frequently before it reaches
maximum stack height and overflows.
• When an obstruction or stall does occur, do the following:
1. Press Stop on the inserter.
2. Clear any obstructions from the inserter and/or the stacker.
3. Press the reset button on the stacker.
4. Press Clear Deck on inserter to ensure materials are cleared.
5. Press Start or follow any additional instructions on the insert-
er's display.