Pitney Bowes OfficeRight DF500, Руководство оператора

Страница: 14 / 51

DF500 Folder Operator Guide
12 SV40214 Rev. A
AUTOMATIC FOLD SETUP
Selecting Paper Size
1. Press the Paper key to select the desired paper size length.
Each press of the key will step through the three standard
paper sizes and “other” and will light the appropriate paper
size indicator on the control panel.
2. At the same time, the display will show the selected paper
length in millimeters. For example:
3. If your paper isn’t a standard size, press the
"
or
!
key, to
change the size. Each key press will change the paper size by
about 1/64" (0.5mm). Holding the key down for more than
one second will increase the step size, allowing large changes
to be made rapidly.
4. When the correct paper size is shown, proceed with “Select-
ing Fold Type” below. NOTE: The DF500’s electronic control
system will not allow you to deviate too far from the standard
settings. This will prevent jams caused by “impossible” folds.
Selecting Fold Type
Before selecting a fold, make sure you have already set the
DF500 to the correct paper size length. This will prevent the ma-
chine from setting up a fold for the wrong paper length, which
could result in a paper jam.
1. Press the Fold Type key to select one of the six pre-pro-
grammed fold types. Each key press will turn on the indicator
associated with each fold type.
2. When you have made your selection, press the Enter key. The
display will show:
3. While the machine is setting up the fold, all keys on the con-
trol panel are disabled and will not respond if pressed.
(continued on next page)
T1 PAPER = 297.Ø
CHG: DONE: Enter
TEMP JOB: 1 READY
ØØØØØØ