Pitney Bowes AddressRight DA70S, Руководство оператора

Страница: 21 / 74

2 • Printer Basics
2-4 SV61665 Rev. C
Setting the Proper Feed Gap
A. Loosen the lock knobs to unlock all three H-Blocks.
B. Lift the H-Blocks to their highest position and lock in place.
C. Place a sample piece of material between the separator
fingers (the lower section of the H-Blocks) and the feed
roller.
D. Lower only the H-Blocks that come in direct contact with the
material and let them touch the material.
E. Lock each separator in place. When lowering the H-Blocks,
check that the material is between the separator tabs and
the feed roller.
Setup Example Using #10 or DL Envelopes:
A. When you set the feed gap for a #10 or DL envelope, note
that the width of the envelope will fall completely under the
inside and middle H-Blocks, but only half way under the
outer H-Block. Follow steps B through D to fix this.
B. Remove the side guide.
C. Place a second envelope next to the first, under the outer
H-Block. Place the second envelope flap down with the short
edge under the outer H-Block.
D. Lock the separator in place.
NOTE: If the separator gap is not set properly, the printer will
misfeed.
• If the gap is too big, the printer will feed doubles (two or
more pieces at the same time).
• If the gap is too small, material will jam at the feed roller
entrance.