INSTALLATION & START-UP
Location
For proper operation and maximum performance, locate the Crisp n’
Hold in an ambient air temperature of 70º F (21ºC).
Avoid areas near exhaust fans where there is active air movement.
For safe operation, locate the unit a reasonable distance from com-
bustible walls and materials.
To prevent injury and damage, locate the unit at a proper and safe
working height. The location should be level, clean of debris, and
strong enough to support the weight of a fully loaded unit.
Start-up
1. Plug the Crisp n’ Hold into a properly grounded electrical recep-
tacle.
2. Ensure all plastic and packaging materials have been removed.
3. Familiarize yourself with the controls.
4. On/Off switch is located inside the cabinet below the product
station. Set POWER switch to “ON” position.
5. Do not load product into the cabinet. Allow the heat to remove
any residual oils which may adhere to inside metal surfaces. A
slight emission of smoke is normal for the first few hours of
operation.
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding
wire with a grounding plug which must be plugged into an
outlet that is properly installed and grounded. In the event of
an electrical short circuit, grounding reduces the risk of elec-
tric shock by providing an escape wire for the electric current.
WARNING—Improper use of the grounding can result in
a risk of electric shock.
Consult a qualified electrician or
serviceman if the grounding instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly grounded.
5
WARNING:
Risk of personal injury
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes.
Failure can result in personal injury
and property damage.
IMPORTANT:
Power cord is 7' long.
If necessary, contact a licensed
electrician to install an appropriate
20 amp electrical circuit with correct
NEMA receptacle.
CAUTION:
Electrical Shock Hazard
The ground prong of the power cord
is part of a system designed to pro-
tect you from electric shock in the
event of internal damage.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
IMPORTANT:
Not under warranty:
Damage to unit due to being
connected to the wrong voltage or
phase is
NOT
covered by warranty.
CAUTION:
Risk of personal injury
Unit is not waterproof, to avoid
electrical shock keep unit and
counter from being submerged in
water. Do not operate if unit has
been submerged in water.
